Whether it is fast charging or slow charging, electric vehicles can accurately display the specific charging amount. Some car owners have found that the charging amount displayed on the charging pile and the car computer are different. Where does the undercharged electricity go?
Components and structure of new energy vehicles:
The three-electric system of BEV is electric drive, electric control, and battery. The small three-electric system related to charging includes OBC, on-board DC/DC, and high-voltage power distribution unit (PDU). When charging, the current passes through the charging gun and enters the car. According to the different properties of the current, the AC power needs to pass through the OBC to convert it into DC power before charging it into the battery. According to the current direction mentioned above, the source of loss is analyzed step by step.

Common charging piles on the market
The conversion efficiency of its charging module is mostly between 90% and 95%, which means that 5% to 15% of the electric energy will be lost in vain during the conversion process. I believe that many BEV owners have noticed that after plugging in the charging gun and starting to charge, the noise of the distribution box will increase instantly, and the internal cooling fan and conversion module will start working. The noise of the fan and the hot air blown out are all losses caused by the charging pile.

Some charging piles use liquid cooling to dissipate heat for the cable. In addition to the heat exchange of the fan, the operation of the water pump will also consume electricity. In addition, the control circuit of the charging pile also needs to consume a certain amount of electricity to maintain its normal operation, such as the communication module and the billing system. Although the power consumption of a single component may be negligible, these are all part of the loss.
Cable length, diameter, and material
Electrical components have losses, and the cable itself will also have losses. Ohm’s law states that current is proportional to voltage and inversely proportional to resistance. In the process of power transmission, we can reduce the current by increasing the voltage, thereby reducing power loss. But in the community and even the distribution box, the voltage is fixed at 380V or 220V. When the cable is too long and the wiring harness is thin, the loss will increase.

In the hot summer, when many BEV owners are fast charging, even if they are not in the car and the air conditioner is not turned on, they can still hear the sound of the cooling fan working when standing at the front of the car. This is because the BMS starts the vehicle compressor to cool the battery in order to control the battery temperature. The energy consumed by the water pump, compressor, and fan is also part of the charging loss.